Description serv-Clip ®2
The patented measuring connector sc-2-A... has been developed for mounting to pressureless hydraulic tubes. Following installation, the measuring connector is capable of permanent use for a working pressure of 630 bar (9100 psi).
The measuring connector sc-2-A... is supplied in a pre-assembled state with measuring connector and needle. Screwing in the measuring connector presses a special-shaped needle through the wall of the tube. Afterwards the measuring connector is screwed out and the needle removed along with the stirrup and a pressure disk.
The measuring connector is now screwed back into the serv-Clip. The measuring point is now sealed off and permanent pressure can be applied up to 630 bar (9100 psi).
This connection is quick and simple to make and is also reliable. The whole process takes only a few minutes to complete. No special tools are required for mounting the serv-Clip.
The system is fully sealed off. Contamination of the hydraulic fluid is ruled out. The operating reliability of the system remains intact.
The measuring point is now permanently available for measurements.
