Pressure sensor DS-1-A-400- 1/4" or 3/4" fluid-Check ®
with serv-Clip Type 1 or Type 2
Installation in only 3 minutes - no cutting pipelines
Accuracy and confidence with pressure sensor DS-1-A-400
Data Sheet
Examples
FM-1-B for sensors
FAQ
DS-1-A-400-1/4" for serv-Clip® Type 1
(for mounting on pressurized pipes)
DS-1-A-400-3/8" for serv-Clip® Type 2
(for mounting on non-pressurized pipes)
For pipes over 3“ (88,9 mm) and wall thickness from 6 mm ask about our adapter SC-XE-607.
Description
In addition to its robust and compact design, this sensor stands out by its high accuracy and its extensive measurement range.
As a standard, the housing and all parts exposed to the liquid are made of stainless steel (Type 1.4571).
Use the same serv-Clip for other measurements:
with SC Type 2 : Installation of Sensors like flow rate, leakage, temperature, aqua, pressure
with SC Type 1: Installation of pressure sensor only
with SC Type 1 and 2: manometers, filters, particle counters
Technical data
- Pressure range 0 ... 400 bar
- Output signal 4 ... 20 mA / 2 wires
- Power supply 12...32V DC
- Operating temperature -40 ... 125 °C
- Ambient temperature -40...105°C
- Protection mode IP 65 DIN EN 60 529
- Accuracy 1,0%
- Linearity +/-0,5%
- Right-angle plug connection DIN EN 175301
- Robust stainless steel housing
- Fully encased sensor element made of stainless
- Special instructions for stainless steel pipes up to 4 mm wall thickness with SC-2 possible.
Option IV: Suitcase with 4 DS and 4 TS sensors
