Home
The super quick minimess serv-Clip fluid-Check connector measurement tube hydraulic pipe measuring points sensorsHydraulic measuring connector serv-Clip®
No only better .different!
- Quick installation (only 3 minutes) - No need to cut open pipes
- Type 1 No shutdown of installations for mounting on pressurized pipes
installation of pressure switch, gauge and sensors, particle counters - Type 2 Short shutdown of installations for mounting on NON-pressurized
add. to type 1- installation of flow rate, leakage, temperature and aqua sensors - Up to 630 bar / 9100 psi - screwed coupling M 16 X 2
- Particle measurement according to ISO or NAS classes
serv-Clip ® facilitates immediate measurement of
- pressure fluid-Check ®
- temperature fluid-Check ®
- flow rate / leakage detection fluid-Check ®
and more... measure immediately, in conjunction with virtually every type of measurement minimess serv-Clip fluid-Check connector measurement tube hydraulic pipe measuring points sensorscoupling and measuring equipment!
For pipe diameters with wall thickness up to 5 mm
serv-Clip ® is a patented product and registered trade mark of BKM-Hagen.
serv-Clip - the multi-measuring connection in 3 minutes installation..
The use of the serv-Clip does away with installation on more than 80% of all normal measuring points.
serv-Clip on new system
You have only to make plants to install normal measuring connectorsminimess serv-Clip fluid-Check connector measurement tube hydraulic pipe measuring points sensors at the necessary measuring points. serv-Clip is installed wherever required.
If required, you can perform measurements immediately at any point on the system.
serv-Clip on older systems
It is possible to retrofit serv-Clip directly at the necessary points of the system.
By means of serv-Clip you are able to carry out measurements at any point on the system.
