serv-Clip Type 1 (for mounting on pressurized pipes)

Immediately operational measuring point. Fault identification and prevention for your machines. Measuring point for your hydraulic, lubrication and cooling systems and more.

Mit serv-Clip® Type 1 (for mounting on pressurized pipes)

This is what you can do instantaneously:
Measure pressure
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters

Why?
Quick and cheap installation (only 3 minutes)
Measurement without switching off
No need to cut tubes
No cleaning necessary

Technical data

• for diameters 10 - 42 mm / Pipe 3/8“ - 2“/ Tube ¼“ to 3“
• Working pressure up to 630 bar/ Steel wall thicknesses up to 5mm
• Working temperature from -40°C to +120 °C
• Viton O-Ring in leak proof clamp
• Special designs for stainless steel pipes and larger diameters upon request

How it works?
A needle is pressed through the wall of the pipe. It uses the principle of plastic deformation to create a leak-proof opening.

Order our service suitcase and save 16%.