Pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes) for hydraulic and gear oils as well as for water-glycol HFC
Installation in only 3 minutes - no cutting pipelines
How it works?
A needle is pressed through the wall of the pipe. It uses the principle of plastic deformation to create a leak-proof opening.
Mit serv-Clip® Type 1 (for mounting on pressurized pipes)
This is what you can do instantaneously:
Measure pressure
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters
Why?
Quick and cheap installation (only 3 minutes)
Measurement without switching off
No need to cut tubes
No cleaning necessary
No contamination of fluids
Technical data
For diameters:
- 10 - 42 mm /Tube 3/8" - 2" / Pipe ¼" to 3"
- Working pressure up to 630 bar (9100 psi)
- Working temperature from -40°C to +120 °C
- Viton O-Ring in leak proof clamp (200°C)
- Installation no possible on stainless steel pipelines (with SC-Type 2 for inst. on non- pressurized pipes up to 4 mm wall thickness possible)
Flyer
FAQ
