Serv-Clip Type2 (for mounting on non-pressurized pipes)

Immediately operational measuring point. Fault identification and prevention for your machines. Measuring point for your hydraulic, lubrication and cooling systems and more.

How it works?
A needle is pressed through the wall of the pipe. It uses the principle of plastic deformation to create a leak-proof opening. Finally you remove the needle and stirrup to measure.


Order our service suitcase and save 15%.

serv-Clip® Type 2 (for mounting on non-pressurized pipes)

This is what you can do instantaneously:
Measure pressure
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters
Measure flow rate and temperature (only with Type 2)

Why?
Quick and cheap installation (only 3 minutes)
Minimal downtime
No need to cut tubes
No cleaning necessary
No competition in the market!


Technical data

  • for diameters 10 - 42 mm / Tube 3/8" - 2"/ Pipe ¼" to 3"
  • Working pressure up to 630 bar/ Steel wall thicknesses up to 5mm
  • Working temperature from -40°C to +120 °C
  • Viton O-Ring in leak proof clamp
  • Special designs for stainless steel pipes and larger diameters upon request

Flyer
Data sheet
Installation
FAQ

get Adobe Reader